How to Install a Convertible Car Seat Properly?

best convertible car seats

Talking about how to Install a Convertible car seat? Convertible car seat installation is one of the safety measures that you need to be keen on to ensure that your child is safe and secure. A convertible car seat which is not properly installed can lead to bad accidents. To avoid such mistakes, it is good to properly install the car seat. Normally, the manufacturer will provide instructions on how to install it. If the installation instructions are not clear to you, ensure that you seek further assistance from an expert. Car seats can have either the seatbelts or the lower anchors to attach to the car. The following are procedures on how to properly install a car seat with wither a seatbelt or a lower anchor;

How to install a convertible car seat with a seatbelt?

  • The first step is to first position the car seat in the back of your car.
  • Once you have positioned it well, thread the seatbelts through the belt path. While threading, ensure that the seatbelt has no twists.
  • After threading the seatbelt, buckle it and then you lock it.
  • Once you are done locking, it is good to press firmly the seat and then tighten it. Ensure that the car seat does not move more than an inch either in the back and forward or in the side to side positions.
  • Finally, once you have positioned and tightened the convertible car seat, ensure that it is at the right positioning angle. The rear-facing car seat should be at 45 degrees from the ground level.

 

How to install a car seat with the lower anchors?

  • The initial step is to position the car seat at the vehicles’ back seat.
  • Secondly, ensure that you can locate the lower anchors in your vehicle.
  • Once you have located them, proceed to connect the car seat’s lower anchor attachment to the car’s lower anchors. While connecting, ensure that the straps are too twisted.
  • Finally, give the car seat a firm press and tighten it to ensure that it does not move even an inch form any side.

 

Common mistakes that should be avoided when installing a car seat

A properly installed car seat is capable of reducing death risks as a result of collisions by 71 percent. Therefore, you need to know the common mistakes made when installing a car seat in order to avoid them. They are as follows;

One of the biggest mistakes that people make when installing a car seat is loose installation. Once you have installed your car seat, the final procedure of pressing and tightening is very vital. While pressing and tightening, you will be able to check for any movements and hence correct them.  If the car seats move for more than one inch after installation, then consider reinstalling it properly.

 

There is an ideal angle that a car seat should be positioned depending on your baby’s weight and age. Many people make a mistake of not checking the car seat’s angle after installation. The manual normally contains the right-angle positioning for your child.

 

It is a big mistake to use again the car seat after an accident. In most cases, after an accident, the car seat gets damaged. This is because as oat absorbs and dissipates the force of collision it is likely to get damaged. Once you are involved in a car crash, the best thing is to get a new car seat for your car.

Check Details on Amazon
Click Here to Leave a Comment Below 0 comments